Positioning the Miter Guide
Place the Miter Guide against the Rip Fence.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and well‑lit. The work area must not allow access by children or pets to prevent distraction and injury.
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow for a drip loop.
3.Make sure that the Base is on a steady level work surface so the water level of the tank can be accurately measured and maintained.
4.There must not be objects, such as utility lines, nearby that will present a hazard while working.
5.Keep workpieces pressed firmly against the Table and Fence while cutting.
6.Mark cut lines using waterproof marker or crayon.
General Operating Instructions
1.Install the Blade and check that the Upper and Lower Blade Gaurds are in place.
2.Fill the Water Tray to the Maximum Fill line on the sides of the Tray and slide it under the Lower Blade Guard, raising the tool slightly to allow the Water Tray to fit. Check that the water level is between the MIN and MAX on the Lower Blade Guard and adjust if needed.
CAUTION: Do not operate the Tile Saw with too little or too much water in the Water Tank. Keep the water level between the minimum and maximum level markings on the Lower Blade Guard.
Lower
Blade
Guard
MAX
MIN
Water Tray
Figure G
SAFETY
SETUP
OPERATION
MAINTENANCE
Item 69231 | For technical questions, please call | Page 11 |