Craftsman 315.21449 owner manual On0, Small Combination Square

,_ WARNING: To prevent accidental starting that could cause possible serious personal injury,

assemble all parts to your saw before connecting it to power supply. Saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades, or when not in use.

•Carefully remove all parts from the carton and place the saw on a level work surface. Separate and check against the list of loose parts.

_ WARNING: If any parts are missing, do not operate this tool until the missing parts are

replaced. Failure to do so could result in possible serious personal injury.

•Do not discard the packing materials until you have carefully inspectedthe saw, identified all parts, and satisfactorily Operated your new saw.

Note: If any parts are damaged or missing, do not attempt to plug in the power cord and turn the switch on until the damaged or miss(ng parts are obtained and are installed correctly.

Check all loose parts from the box with the list below. For your convienence when identifying parts, items A-I below have been drawn actual size. Assemble according to the instructions on the following pages.

A.	Flat Head Screw (1/4-20 x 7/8 in.)	3
B.	Hex Nut (1/4-20)	3
C.	Switch Key	1
D.	Truss Head Screw (1/4-20 x 5/8 in.)	1
E.	Wing Nut (1/4-20)	1
F.	Screw (M5 x 8)	1
G.	Scale Indicator	1
H.	Throat Plate	1
I,	Hex Key (1/8in.)	1	on0
J.	Saw Table (not shown)	t
K.	Owner's Manual (not shown)	t

L

Fig. 2

The following tools (not included) are needed for assembly and alignment:

_ •	#2 Phillips Screwddver
•	Adjustable Wrench	#2 PHILLIPSSCREWDRIVER

•Small Combination Square

SMALL
COMBINATION
SQUARE	Fig. 3

8