IA WARNING)
For your safety, do not plug in your cutting tool or try to use any accessory until it is completely assembled and installed according to these instructions, and
until you have read and understood this Owner's Manual.
Failure to follow these safety rules will result in risk of serious Injury.
1.WEAR EYE PROTECTION. This high speed tool will throw particles from the workpiese dudng operation. Make sure safety glasses have side shields.
2.USE FACE OR DUST MASK along with safety goggles if cutting or muting operation is dusty, Make sure work area is well ventilated,
3.USE HEARING PROTECTION, perticulady dunng extended pedods of operation.
4.NEVER USE DULL OR DAMAGED BITS, Damaged bits can break without warning. Dull bits may overload the motor, cut slewiy and are difficult to control. They will also overheat and possibly break.
5.ALWAYS MAKE SURE THE WORKPIECE IS FREE OF NAILS AND OTHER FOREIGN OBJECTS. If the
bit stdkes a nail it will jump sideways and possibly break.
6.DO NOT USE THIS TOOL FOR DRILUNG HOLES. It is NOT intended to be used as a ddlL
7.ALLOW CLEARANCE UNDER WORKPIECE for bit to travel. Never place workplace on hard surfaces such as concrete etc. The bit may jump or break when contacting a surface other than the one being cut,
8.ALWAYS SET THE DEPTH GUIDE TO THE APPROPRIATE DEPTH. Use tool with the depth
guide fiat against the work surface for better control of the tool.
9.NEVER USE THE TOOL WITHOUT THE SOLE pLATE, PRECISION HANDLE OR ROUTER BASE attached and appropriately adjusted.
10.ALWAYS CLAMP WORKPIECE TO HOLD IT S1T=ADY WHEN CUTnNG, This will free both hands for operating the tool.
11.NEVER HOLD THE WORKPIECE IN ONE HAND while operating the tool with the other hand.
12.NEVER PLACE HANDS IN THE PATH OF THE cUTrER AND UNDER THE WORKPIECE.
13.NEVER START THE TOOL WHEN THE BIT IS TOUCHING THE WORKPIECE. The bit may catch the workplace causing loss of control,
t4. ALWAYS HOLD THE TOOL WITH I_VO HANDS DURING
t5. TURN OFF ALL CIRCUIT BREAKERS AND
REMOVE ALL FUSES in the work area when cutting into walls or blind areas.
16, ALWAYS HOLD THE TOOL BYTHE INSULATED
GRIPPING SURFACES ON THE BODY OF THE TOOL where there is any possibilityof the cutting bit contacting hidden electrical wires or the cord of the tool. Contact with "live" wires will make exposed metal
parts of the tool "live" causing an electrical shock to the operator.
17, WHEN CUTTING DRYWALL ELECTRICAL OUTLET OPENINGS using the outlet as a guide, always cut in a counter clockwise direction. The natural tendency of the tool to pull to the left will cause a "hugging" action toward the outlet box, resulting in a neatar cut.
18.NEVER LAY THE TOOL DOWN UNTIL THE CUTTING BIT COMES TO A COMPLETE STOP. A
spinning bit can come in contact with the surface and pull it out of your control,
19, NEVER TOUCH THE CUTRNG BIT IMMEDIATELY AFTER USE. The bit will be too hat to be handled with
bars hands and will bum your fingers.
20, ALWAYS
SAVE THESE INSTRUCTIONS FOR REFERENCE
4