I I I I
1.Place carton on the floor in an area with sufficient space to inspect your saw.
2.Remove carton and packing materials from around tool.
3.Inspect the saw for loose or damaged parts. If any parts are damaged or missing, return the saw to your nearest Sears Store to have it replaced.
LOOSE PARTS LIST
The following items are included with your tile wet saw:
|
|
| |||
B |
| Assembly | Handle | ||
| G | Assembly |
| ||
| Handle | Screws | (2) | ||
|
| ||||
|
| ||||
|
| Washers | (4) |
| |
|
| 2 reg. & 2 locking | |||
|
| ||||
|
| ||||
| A | ||||
| Wrench |
|
| ||
|
|
|
| ||
|
|
| |||
|
| ||||
H |
| (2 additional) |
| ||
|
| ||||
LOOSE PARTS LIST cont.
8.To stabilize and level the tile saw, adjust the leveling "set screw" located on the bottom of the left front leg (Fig. 10).
9.Attach blade/cutting assembly handle with screws provided. Put one of each washer between screw and blade and tighten screws (Fig. 11).
10.The cutting unit is locked into place during shipment. Loosen the butterfly knob located on one end of the bridge (Fig. 12) before using tool. When not in use, keep cutting unit locked in place to prevent its rolling back and forth along bridge. There is also a second locking mechanism on the blade/cutting assembly that can also be used to lock the blade cutting assembly anywhere along the bridge of the saw (Fig. 13).
_WARNING:If any parts are missing, DO NOT operate this saw until the missing parts are replaced. Failure to do so could result in serious personal injury.
z_CAUTION: Follow all of the assembly and installation instructions in
this manual before connecting the tile saw to a power source or turning it on.
4.Lay tool on a level surface (Fig. 4).
5.To release saw table legs, pull out hook from latch and attach to peg on table base (fig. 5 and fig. 6). Grab and pull the single padded table handle on one end of tile saw and lift to unfold the first set of legs (Fig.7).
6.Slide peg on leg into notch on table base (Fig. 8). Lock legs into place by tightening butterfly knobs; repeat on other side.
7.Once legs are securely locked in place, note that telescoping legs can be adjusted to 3 different heights by loosening "screw knobs" and selecting the appropriate pinhole for desired height. To adjust height, loosen knobs on telescoping legs and realign screw knobs to desired operating height; tighten knobs to secure in place. (Fig. 9)
14 | 15 |
I
I1-19-06
I
I