Assembling the Spray Wand

Introduction

Prepare to Assemble

This manual contains information for the proper assembly, operation and care of your SP210 sprayer. Carefully read and follow the instructions contained in this manual before operat- ing your sprayer.

Trigger

Valve

Pump

Handle

Wand

Cylinder

Cap

Nozzle

	Carry
Lid	Strap

Pressure

Relief Valve

Unpack the following items shipped in your sprayer box:

■Wand

■ Tank Assembly

■Owner’s/Operator’s Manual

® Tank

Specifications

Net Weight	4.8 pounds (2.2 kg)
Tank Capacity	2.0 U.S. gallons (7.6 liters)
Tank Material	UV Protected Polyethylene
Fill Opening Diameter	3.6 inches (92 mm)
Pump Type/Material	Piston/Polyethylene
Operating Pressure	10-45 psi (0.7-3.15 kg/sq.cm)
Wand Assembly Length	27.5 inches (698.5 mm)
Hose Length	69 3/4 inches (1771 mm)
Nozzle Installed	Red Adjustable Cone

Specifications subject to change without notice.

Wand	Screw	Trigger
	Cap	Valve

Push the wand into the trigger valve and secure with screw cap. Hand tighten to prevent leakage.

CAUTION!

Do not overtighten!

IMPORTANT!

After assembling the sprayer, fill the tank with clear water, and lay it on its side. Check for leaks. Return sprayer to its upright position. Pump the sprayer 10-40 times or until the pressure relief valve is released and check for leaks. Most leaks can be stopped by tightening the appropriate connec- tion or fitting. Any leaks must be stopped prior to filling the sprayer with chemicals.

WARNING!

Always relieve pressure from the sprayer tank by pulling the pressure relief valve before removing the tank lid.