General Safety Instructions for Power Tools

Using power tools of any kind can be dangerous if safe operating procedures are not followed. Recognizing the hazards of each tool and using them with respect and caution will considerably limit the possibility of personal injury. However, if safety precautions are ignored, personal injury will likely result. Always use common sense – your personal safety is your responsibility.

1.Know your power tool. Read and understand the Operator’s Manual and observe the warnings and instruction labels affixed to the tool.

2.Properly ground all tools.

3.Keep guards in place.

4.Remove adjusting keys and wrenches.

5.Keep work area clean and dry.

6.Keep children away.

7.Never leave running machines/tools unattended.

8.Disconnect tools from service.

9.Use correct tools for the job.

10.Never force a tool.

11.Wear safety apparel.

12.Wear safety glasses/goggles.

13.Never stand or sit on tools.

14.Replace damaged components immediately.

15.Make sure your work platform is sufficiently sturdy to do the specific job at hand.

16.Properly anchor power tools to work stands.

17.Use correct blade for job being done.

18.Think Safety. Safety is a combination of operator awareness, common sense and alertness at all times.

Safety Instructions for

Miter Saw Stands

1.Use caution when folding or unfolding legs to limit any finger pinch points.

2.Place stand on flat and level surface to keep tool from rocking or tipping.

3.Make certain that work support extensions are within safe operating limits, and are properly locked in place before using tool. Do not exceed 500 lbs. on main frame table.

4.Test the setup for stability before proceeding with work.

5.Be sure the miter saw is tightened securely at all mountings before use or folding the stand for transport.