Bevel Cutting
Warning: Before adjusting the cutting angles, be sure the saw is unplugged from the power supply.
The base plate can be tilted to cut any angle between 0 and 45 degrees right and left. Loosen the base plate adjustment screw and then rotate the base plate left or right to the desired angle. Tighten the base plate adjustment screw to secure base plate.
Fig. 5
Note: The base plate has a scale for setting 0 to 45 degrees. Use a protractor to set other angles.
Orbital Cutting
The cutting mode selector can be adjusted to select the straight cutting mode or orbital cutting mode. This saw has 4 position settings. The setting marked 0 is for straight cutting and the settings marked I, II and III are for orbital cutting.
Use of higher Orbit settings when performing intricate scroll cuts may cause blade breakage. Use lower orbit settings for scrolling. Orbit position “0” will produce the most accurate cuts with less splintering and the longest blade life.
Fig. 6
9