Read ALL Instructions

on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source.

11.Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take charger to an authorized service center.

12.Do not disassemble charger, take it to an authorized service center when service or repair is required. Incorrect reassemble may result in a risk of electric shock, electrocution or fire.

13.To reduce risk of electric shock, unplug charger from outlet before attempting any cleaning. Removing the battery pack will not reduce this risk.

14.Never attempt to connect 2 chargers together.

15.DO NOT store or use the tool and battery pack in locations where the temperature may reach or exceed 105F° (such as outside sheds or metal buildings in summer).

16.The charger is designed to operate on standard household electrical power (120 volts). Do not attempt to use it on any other voltage.

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY PACKS

The battery packs are not fully charged when taken out of the carton! First read the safety instructions below. Then follow charging notes and procedures.

1.Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire.

2.A small leakage of liquid from the battery pack cells may occur under extreme usage or temperature conditions. This does not indicate a failure.

However, if the outer seal is broken and this leakage gets on your skin: 11

a. Wash quickly with soap and water.

b.Neutralize with a mild acid such as lemon juice or vinegar.

c.If battery liquid gets in your eyes, flush them with clean water for a minimum of 2 minutes and seek immediate medical attention. (medical notes: the liquid is 25-35% solution of potassium hydroxide.)

3.Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, immediately discontinue use and do not recharge.

4.Do not carry extra battery packs in pockets, or tool boxes along with other metal objects. Battery pack could be short circuited causing damage to the battery pack and possibly causing severe burns or fire.

5.Charge the battery packs only in chargers.

6.NOTE: review and observe all of the “IMPORTANT CHARGING NOTES” in the charger instruction section of this manual.

7.NOTE: the rechargeable batteries contain nickel-cadmium. Cadmium is considered to be a toxic material by the Environmental Protection Agency. Before disposing of damaged or worn out Nickel-Cadmium battery packs, check with your state Environmental Protection Agency to find out about special restrictions on the disposal of these battery packs or return them to a certified service center for recycling.

Changing the saw blade (See Fig.1)

Remove the battery pack before carrying out any work on the machine.

1.Hold the work spindle still by pressing the spindle lock down and loosen the screw. Remove washer and clamping disc.

2.Swing swivel guard backwards, hold it still, and remove the saw blade from the clamping flange.

3.Fit the new saw blade by following the above steps in the reverse order. The arrow on the saw-blade must point in the same direction as the direction of rotation arrow.

Adjusting the Guide-plate (See Fig. 2)

If a correction of the 90˚ angle of the guide-plate to the saw blade is necessary,