N0150 05/05.qxd 27/5/05 10:28 am Page 10
|
|
| TROUBLE SHOOTING | |
PROBLEM | CAUSE | ACTION REQUIRED | ||
The paint drips | Paint too diluted | Add undiluted material | ||
on item | Paint volume | Reduce the paint flow | ||
being painted | too high | by turning Fluid Adjusting Screw | ||
|
|
| Moving too slowly | Increase speed of application |
|
|
| Spray gun trigger being | Release trigger earlier |
|
|
| held for too long |
|
|
|
| Spray gun too close | Increase the distance between |
|
|
|
| gun and workpiece |
Paint is thin or |
| Paint too diluted | Add undiluted material | |
irregular | Paint volume | Increase the paint flow by turning | ||
|
|
| too low | Fluid Adjusting Screw |
|
|
| Moving too fast | Reduce speed of application |
|
|
| Spray gun clogged | Clean the gun |
|
|
| Spray gun too far away | Reduce the distance between |
|
|
|
| gun and work piece |
No spray pattern | Paint too thick | Add thinner | ||
being produced | Gun clogged | Clean the spray gun | ||
|
|
| Pick up pipe clogged | Clean Paint Feed Tube |
|
|
|
|
|
|
|
| Air hose split | Replace air hose |
|
|
| Gritty paint | Filter the paint |
|
|
| Container almost | Refill container |
|
|
| empty |
|
|
|
| Spray gun at an angle | Ensure Paint Feed Tube |
|
|
|
| is angled towards paint |
|
|
|
|
|
|
|
| Air intake | Check the condition of |
|
|
| blocked | the Filter and clean as neccessary |
Unit will not | Circuit breaker tripped | Check the back of the unit. If the circuit | ||
start | (HV7000 unit) | breaker has tripped, a white push button | ||
|
|
|
| indicator will appear. Push in to reset. |
|
|
|
| If this does not cure the problem, please |
|
|
|
| refer to your nearest service agent. |
|
|
|
|
|
|
|
| House circuit breaker | Check and reset if required. |
10