HELPFUL HINTS
1.Evenly control the speed of movement of the spray gun. A fast speed will give a thin coat and a slow speed will give a thick coat.
2.Only apply one coat at a time. If an additional coat is required, follow the paint manufacturer’s instructions
| for drying times. |
|
3. | If spraying small areas or objects keep the output setting low as this will avoid |
|
| excessive use of paints and will minimize overspray. |
|
4. | When spraying large areas or objects, it is best to use a |
|
| from left to right then up or down or |
|
| (Fig. 5). |
|
5. | Avoid stopping and starting when spraying as this can lead to too much or not |
|
| enough material on a surface. |
|
6. | To ensure edges are covered, commence spraying just to the side of area being |
|
| sprayed. |
|
7. | CLEAN SPRAYER AFTER EVERY USE (SEE CLEANING INSTRUCTIONS) | Fig.5 |
|
|
CLEANING INSTRUCTIONS
THE SPRAY GUN MUST BE THOROUGHLY CLEANED IMMEDIATELY AFTER USE. IF THE PAINT DRIES INSIDE THE GUN, CLEANING WILL BECOME MUCH MORE DIFFICULT AND MAY RENDER THE GUN INOPERABLE. THIS IS NOT COVERED BY THE LIMITED WARRANTY.
The spray gun is the same as a paintbrush, if it is not cleaned the paint will go hard and can become useless. You must therefore clean this out after use.
SPRAY GUN
●Remove the gun container.
●Pour any leftover paint into its container so that it can be used for the future.
●Pour a quantity of the respective thinner into container, shake the spray gun lightly, reassemble the gun, then spray this liquid through the gun. Repeat this until the thinner being sprayed is coming through with no traces of paint.
●Clean any traces of paint off the outside of the spray gun.
●Clean the container Seal (11) inside the spray gun body.
FLUID TIP & NEEDLE
●Unscrew Air Cap Ring (1)
●Remove the Air Cap (2)
●Completely remove Fluid Adjusting Screw (8)
●Remove the Spring (7)
●Remove the Fluid Tip Needle (6) by gently pulling the trigger
●Remove the Fluid Tip (4)
●Remove Direction Plate noting the position of notches (3)
●Remove Fluid Tip Seal (5)
●Remove Paint Container Seal (11)
●Place all of these items into a container and clean them using a brush and clean thinners
●Clean the inside of the body of the gun
●Thoroughly dry these parts before reassembling
●Grease the Gland (10). (USE PETROLEUM JELLY. DO NOT USE SILICONE BASED GREASE.)
●Reassemble parts in reverse order.
It is recommended fitting the Fluid Tip (4) prior to the needle.
NEVER DISPOSE OF PAINTS OR SOLVENTS INTO DRAINS. CONTACT YOUR LOCAL AGENCY TO ARRANGE COLLECTION OR FOR DETAILS OF NEAREST REGISTERED DISPOSAL SITE.
6