Table of Contents
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Ground the system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 System Component Information . . . . . . . . . . . . . . . . . . 7 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Pressure relief procedure . . . . . . . . . . . . . . . . . . . . . . . . 9 Flushing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Graco Phone Number . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Symbols
Warning Symbol
WARNING
This symbol alerts you to the possibility of serious injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This symbol alerts you to the possibility of damage to or destruction of equipment if you do not follow the instructions.
WARNING
PRESSURIZED FLUID HAZARD
Spray from the gun, hose leaks or ruptured components can splash fluid in the eyes or on the skin and cause serious injury.
DDo not stop or deflect fluid leaks with your hand, body, glove or rag.
DFollow the Pressure Relief Procedure on page 9 whenever you: are instructed to relieve pres- sure; stop spraying; clean, check, or service the equipment; or install or clean the spray nozzle.
DTighten all fluid connections before each use.
DCheck the hoses, tubes and couplings daily. Replace worn, damaged, or loose parts immediately. Permanently coupled hoses cannot be repaired; replace the entire hose.
DHandle and route hoses and tubes carefully. Keep the hoses and tubes away from moving parts and hot surfaces. Do not use the hoses to pull equipment. Do not expose Graco hoses to tempera- tures above 180_F (82_C) or below
FIRE AND EXPLOSION HAZARD
Improper grounding, poor air ventilation, open flames or sparks can cause a hazardous condition and result in a fire or explosion and serious injury.
DGround the equipment and the object being sprayed. See Ground the system on page 6.
DIf there is any static sparking while using the equipment, stop spraying immediately. Identify and correct the problem.
DProvide fresh air ventilation to avoid the buildup of flammable vapors from the solvent or the fluid being sprayed.
DDo not smoke in the spray area.
DExtinguish all open flames or pilot lights in the spray area.
DDo not turn on or off any light switch in the spray area.
DElectrically disconnect all equipment in the spray area.
DKeep the spray area free of debris, including solvent, rags and gasoline.
DDo not operate a gasoline engine in the spray area.
2308455