Graco Inc 308235, 237691, 235459 manual Injection Hazard, Moving Parts Hazard, Recoil Hazard

Page 3

WARNING

INJECTION HAZARD

Spray from the gun, leaks or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury.

DFluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate medi-

cal attention.

DDo not point the gun at anyone or at any part of the body.

DDo not put your hand or fingers over the spray tip.

DDo not stop or deflect leaks with your hand, body, glove or rag.

DDo not “blow back” fluid; this is not an air spray system.

DAlways have the tip guard and the trigger guard on the gun when spraying.

DCheck the gun diffuser operation weekly. See page 8.

DBe sure the gun trigger safety operates before spraying.

DLock the gun trigger safety when you stop spraying.

DFollow the Pressure Relief Procedure on page 5 if the spray tip clogs and before cleaning, checking or servicing the equipment.

DTighten all fluid connections before operating the equipment.

DCheck the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do not repair high pressure couplings; you must replace the entire hose.

DFluid hoses must have spring guards on both ends, to help protect them from rupture caused by kinks or bends near the couplings.

MOVING PARTS HAZARD

Moving parts can pinch or amputate your fingers.

DKeep clear of all moving parts when starting or operating the pump.

DBefore servicing the equipment, follow the Pressure Relief Procedure on page 5 to prevent the equipment from starting unexpectedly.

RECOIL HAZARD

Due to the high pressure fluid emitted, a strong recoil action may occur when you trigger this gun. If you are unprepared, your hand could be forced back toward your body or you could lose your balance and fall, resulting in serious injury.

 

Image 3
Contents Model 235-458, Series C Model 235-457, Series CModel 237-691, Series B Model 235-459, Series DSymbols Table of ContentsInjection Hazard Moving Parts HazardRecoil Hazard Toxic Fluid Hazard Fire and Explosion HazardSystem Requirements Installation/OperationPressure Relief Procedure How to Use the Gun Trigger SafetyHow to Adjust the Spray Pattern How to Use the GunCleaning during the day How to Clean the Spray Tip Clear a Spray Tip ObstructionHow to Flush the Gun How to Check the Gun Diffuser OperationNeedle Replacement Service38235 Model 235-457, Series C PartsPage Tools AccessoriesFilters Swivels and Whip HosesGraco Phone Number Technical DataChanged Model 237-691, Series C To Model 237-691, Series B Manual Change SummaryWarranty Graco Warranty and Disclaimers