Grizzly H3257, H3256 instruction manual Lubrication

Page 16

Lubrication

F

A

E

B

C

D

Figure 15. Lubrication points.

Lubricate the following areas with a non- silicon spray gun lubricant after cleaning.

A.Atomizing Cap Threads

B.Air Valve Packing

C.Trigger Pin

D.Air Flow Control Valve

E.Pattern Control

F.Fluid Control Knob

Allow the lubricant to coat threads, and run into gun body to lubricate all moving parts and seals.

-16-

Model H3256/H3257 Spray Gun

Image 16
Contents Spray GUN Page Table of Contents Safety Instructions For Pneumatic Tools SafetyBefore Operating This Equipment Safety Instructions For Pneumatic Tools Additional Safety Instructions for Spray Guns Operating PRESSURE. doIntroduction Foreword Contact InformationTool Data Sheet SET UP InventoryAssembly ControlsOperations SprayingSpray technique YesNo Atomizing Cap Fan Adjustments Fan adjustment Model H3256/H3257 Spray GunAccessories G6261-Campbell Hausfeld Water FilterMaintenance CleaningLubrication Troubleshooting Symptom Possible Cause SolutionSymptom Possible Cause Solution Model H3256/H3257 Spray Gun Parts Breakdown H3256 REF DescriptionParts Breakdown H3257 Warranty and Returns Warranty Card Place Stamp Here