AssemblyControls

1.Insert the filter into the gun body (see Figure 3).

Figure 3. Installing filter.

2.Screw the cup onto the top of the body.

3.Attach the air hose to the spray gun with a 1⁄4" NPS quick connect set-up (not included).

4.Attach the spray gun to an air hose regulated between 29 and 50 PSI.

Note: For the best results, use a hose that will be dedicated for spray use only. Do not use a hose that has been used with an in-line oiler or other pos- sible contaminant.

If you need additional help with this assem- bly, call our Technical Support at: (570) 546-9663.

Atomizing Cap
	Cup
	Pattern Control
Trigger	Fluid Control
	Fluid Control
Air Flow Control

Figure 4. Controls.

1.Fluid Control: Controls the volume of material that travels through the fluid tip.

2.Pattern Control: Adjusts the spray pattern from a round pattern to a wide fan.

3.Air Flow Control: Controls the fluid pressure inside the spray gun (H7667 only).

4.Atomizing Cap: Controls the spray pattern from vertical to horizontal.

5.Trigger: Two stage trigger. Stage one only releases compressed air for blowing off the work piece. Stage two sprays material.

6.Cup: 600ml plastic cup allows easy viewing of material level. Includes a vented cap.

-10-	Model H7666/H7667 LVLP Spray Gun