Grizzly G5352 instruction manual Lubrication

Page 14

Lubrication

F

A

E

B

C

D

Figure 14. Lubrication points.

Lubricate the following areas with a non- silicon spray gun lubricant after cleaning.

A.Atomizing Cap Threads

B.Air Valve Packing

C.Trigger Pin

D.Air Flow Control Valve

E.Pattern Control

F.Fluid Control Knob

Allow the lubricant to coat threads, and run into gun body to lubricate all moving parts and seals.

-14-	Model G5352 Spray Gun

Image 14

Contents Spray GUN Model G5352 Before Operating This Equipment SafetySafety Instructions For Pneumatic Tools Mation about proper operation of the equipmentSafety Instructions For Pneumatic Tools Additional Safety Instructions for Spray Guns Operating PRESSURE. doIntroduction Foreword Contact Information3.5 BAR G5352600 ml 21-50 PSIModel G5352 Inventory Figure SET UPInventoryAssembly To assemble the spray gunControls ControlsTo use your spray gun OperationsSpraying Spray technique YesNo Atomizing Cap Fan Adjustments Fan adjustment Model G5352 Spray GunH7274-Campbell Hausfeld Pressure Regulator AccessoriesG6261-Campbell Hausfeld Water Filter H3174-Air Blow Gun with 2 TipsTo clean your spray gun MaintenanceCleaning Disconnect the gun from the com- pressed airLubrication Troubleshooting Symptom Possible Cause SolutionSymptom Possible Cause Solution Parts Breakdown G5352 REF DescriptionWarranty and Returns Warranty Card Name Street CityStateZip BOX BELLINGHAM, WA