the Tank (1) and empty any remaining liquid into a safe and secure container. Clean the Sprayer thoroughly with agents recommended by the chemical manu- facturer. Allow the unit to
| TROUBLESHOOTING | ||
|
|
|
|
|
|
|
|
| Problem | Possible Solution |
|
| Unit does not spray. | Make sure there is an adequate amount of |
|
|
| liquid in the Tank. |
|
|
| Pump the Hand Pump Assy. to pressurize the |
|
|
| system. (Do not squeeze the Trigger on the |
|
|
| Spray Gun Assembly when performing this |
|
|
| procedure.) |
|
|
| Make sure the Cap is screwed on tightly. |
|
|
| Make sure all connections to the Tank are |
|
|
| secure. |
|
|
| Make sure all connections on the Spray Gun |
|
|
| Assy. are secure. |
|
|
| Make sure the Nozzle on the Spray Gun Assy. |
|
|
| is clear of dirt and debris. |
|
| The spray pattern is undesirable. | Adjust the Nozzle on the Spray Gun Assy. to a |
|
|
| “pinpoint” or “fan” pattern. |
|
|
| Make sure the Nozzle on the Spray Gun Assy. |
|
|
| is clear of dirt and debris. |
|
INSPECTION, MAINTENANCE, AND CLEANING
1.
CAUTION! Always
2.Before each use, inspect the general condition of the Sprayer. Check for misalignment or binding of moving parts, damaged or loose parts, dirt or debris in the Filter, and any other condition that may affect the tool’s safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
3.Periodically, lubricate all moving parts of the Handle Pump Assembly.
4.To clean: If using liquid chemicals, flush the interior and clean the exterior of the
SKU 93302 For technical questions, please call