Harbor Freight Tools 98896 Functional Description, Initial Tool Set Up Assembly

Page 8

Functional Description

refer to the Assembly Diagram near the end of this manual.

Specifications

Air Pressure Range

90 PSI

Maximum Air Pressure

90 PSI

Air Inlet

1/4" -18 NPT

Maximum Speed*

700 RPM

Air Consumption

5 CFM @ 90 PSI

Arbor/Chuck Capacity

1/16 - 1/2"

*Maximum speed at stated maximum air pressure. Excess air pressure is hazardous and may cause the tool to exceed stated maximum speed.

Components and Controls

Trigger

Forward/Reverse

Lever

Fig. 1

1.Reversible feature controled by the Forward/Reverse lever next to the power trigger. (See Fig. 1.) Move switch up toward “F” for forward and down toward “R” for reverse

Initial Tool Set Up/

Assembly

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages,

Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown throughout the manual as soon as possible.

This air tool may be shipped with a protective plug covering the air inlet. Remove this plug before set up.

Air Supply

To prevent explosion:

Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.

Fig. 2

1.Incorporate an in-line oiler, shut-off valve, regulator with pressure gauge,

SKU 98896

For technical questions, please call 1-800-444-3353.

Page 8

Image 8
Contents Reversible AIR Drill Contents Safety Alert Symbol and Signal Words Save This ManualGeneral Work areaPersonal safety Tool use and careService Air sourceSymbol Definitions Specific Safety InstructionsMin Ft-lbVibration Precautions Initial Tool Set Up Assembly Functional DescriptionInjury from accidental operation Tool Set Up Operating InstructionsWork Piece and Work Area Set Up General Operating InstructionsUser-Maintenance Instructions Cleaning, Maintenance, LubricationTroubleshooting Problem Possible Causes Likely SolutionsParts List Assembly Diagram Limited 1 Year warranty