16. Maintenance
For details of maintenance work required for the drill motor, please refer to the enclosed motor manufacturer’s documentation.
Routine Checks
Check electrical connections routinely before each use.
The following routine checks should be carried out monthly:
Check that all screws and fastening elements are properly secure.
Check the feed handle for easy movement.
Check the drive for easy movement and noise.
Check the column for wear and damage.
Check for movement or play in the drill carriage.
Always disconnect the electrical plug before cleaning your drill stand. The drill is virtually
Adjusting Carriage
Rollers
Loosen the locknut (1) using a 19mm open end wrench, turn the eccentric shaft (2) using an 8mm open end wrench, so there is only slight pressure of the roller in contact with the column wear plates (3). Holding the eccentric shaft in place, tighten the locknut. Follow this procedure for both adjusting rollers.
If you are unable to achieve proper adjust- ment, the rollers and/or column wear plates may need to be replaced.
1
2
3
125