Direction Switch
The direction switch can be placed in the center position to prevent the drill from operating, to the right for clockwise bit rotation, or to the left for counterclockwise rotation.
To set the drilling rotation:
1. To place the direction switch (Figure
2) in the lock (center) position, push the switch until it protrudes equally from both sides of the drill.
Figure 2. Direction switch.
2. Push the direction switch in from the right side for clockwise rotation (for- ward).
3. Push the direction switch from the left side for counterclockwise rotation (reverse).
4. Pull the trigger and look at the lighted arrows on the top of the drill to confirm direction.
Installing Bits
This drill is intended for use with drill bits or screwdriver bits with up to 3⁄8" shanks.
To install a bit:
1.Place the direction switch in the lock (center) position.
2.Hold the chuck by the collar while turn- ing the sleeve (Figure 3) to open or close the chuck jaws.
Chuck
Collar
Chuck
Sleeve
Figure 3. Inserting a bit into the chuck.
2.Adjust the jaws to the approximate diameter of the bit or driver and insert the shank into the chuck.
3.Turn the sleeve clockwise to tighten the chuck around the bit or driver. Check the tightness periodically while using the tool.
Note: “Power tightening” (holding the sleeve while running the drill) can cause a loose grip on the bit or driver and potential damage to chuck jaws.
4.To release the bit or driver, hold the chuck collar, and turn the sleeve coun- terclockwise.
Note: The bit may be hot after use. Use gloves when removing.