Grizzly H8370 Functional Overview, Installation, Tools Needed Qty, To install the power feed

Page 2

Functional Overview

The Model H8370 power feed is designed to install on the left side of a mill/drill table to pro- vide powered longitudinal movement of the table. Refer to Figures 2–3and the descriptions below to become familiar with the functional parts of the power feed system.

A

B

C D

E

Figure 2. Power feed controls.

F

G

Figure 3. Limit switch and stops.

A.Direction Lever: Starts, reverses, and stops longitudinal table movement.

B.Rapid Movement Button: Moves the table at the maximum speed in the direction select- ed.

C.ON/OFF Switch: The master power switch for the power feed.

-2-

D.Speed Dial: Controls the speed that the table moves—turn the dial clockwise to increase the speed.

E.Power Lamp: Lights when the power feed is turned ON.

F.Limit Stops: Activate the limit switch. Secure these devices along the table to set the range of movement.

G.Limit Switch: Stops powered table move- ment when either limit stop presses a plunger on the switch.

Installation

 

Tools Needed

Qty

Hex Wrench 2.5mm

1

Hex Wrench 5mm

1

Hex Wrench 6mm

1

Wrench 12mm

1

To install the power feed:

 

1.DISCONNECT MILL/DRILL FROM POWER!

2.Remove the handle assembly from the left side of the longitudinal leadscrew.

3.Slide the provided leadscrew gear onto the leadscrew and into the fingers of the coupler, as shown in Figure 4, then tighten the set screw of the gear to secure it.

Coupler

Leadscrew

Set Screw

Gear

Figure 4. Leadscrew gear installed onto the

leadscrew.

H8370 Power Feed for Mill/Drills

Image 2
Contents Ing the entire setup pro SpecificationsWear safety glasses dur InventoryDisconnect MILL/DRILL from Power InstallationTo install the power feed Functional OverviewPower feed drive gear and leadscrew Gear properly meshed Maintenance Disconnect the MILL/DRILL and Power Feed from Power