Grizzly G8597 1 /2-inch instruction sheet Safety, Before Operating This Equipment

Page 3

SAFETY

For Your Own Safety Read Instruction Manual

Before Operating This Equipment

The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progres- sion of symbols is described below. Remember that safety messages by them- selves do not eliminate danger and are not a substitute for proper accident pre- vention measures.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, MAY result in minor or moderate injury. It may also be used to alert against unsafe practices.

This symbol is used to alert the user to useful information NOTICE about proper operation of the equipment.

Safety Instructions For Power Tools

1.KEEP ALL SAFETY DEVICES IN PLACE and in working order.

2.REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of check- ing to see that keys and adjusting wrenches are removed from tool before turning on.

3.KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.

4.DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use power tools in damp or wet locations, or where any flammable or noxious fumes may exist. Keep work area well lighted.

5.KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safe distance from work area.

6.MAKE WORK SHOP CHILD PROOF with padlocks, master switches, or by removing starter keys.

7.DON’T FORCE TOOL. It will do the job better and safer at the rate for which it was designed.

8.USE RIGHT TOOL. Don’t force tool or attachment to do a job for which it was not designed.

-3-

G8596/G8597 18V Cordless Drill

Image 3
Contents 18V Cordless Power Drills Page Before Operating This Equipment Safety100ft AMP Length RatingDo not Store Battery with Charging SafetyBefore YOU Start Battery charging with the standard charger 2 piece chargerAmerican National Standards Institute Ansi Inserting Battery Into DrillOperation Inserting and Removing Bits and DriversOperating the drill OPERATION, CONT’DMaintenance Operating Guides and TipsDisposed of properly. Refer to the Grizzly Warranty and Returns G8596/G8597 18V Cordless Drill Warranty Card Grizzly INDUSTRIAL, INC