LED Work area light

The drill has 3 LED lights (11) to illuminate the work area and improve vision when drilling in areas with insufficient light.

To turn the LED lights on and off depress the LED light switch (13).

Using the drill

Use the forward/reverse switch (4) to select the direction of rotation, then pull the trigger (3). This trigger switch is an electronic variable speed control which enables the user to vary the speed continuously. The speed varies according to how far the trigger switch is depressed, the further it is depressed the faster the chuck will rotate and the lighter it is depressed, the slower it will rotate.

To stop the drill, release the trigger switch.

Note. You can only change the direction of rotation of the drill using the forward/reverse switch when the trigger is NOT depressed.

Forward/reverse switch

This switch (4) will allow you to change the direction of the motor while the trigger switch is not depressed.

Drilling uses the forward mode. The reverse mode is intended for the removal of screws.

Adjustable torque

This drill is equipped with 20 torque settings plus one drill setting which are controlled by the torque collar (2). By rotating the collar behind the chuck, it is possible to adjust the torque.

This will allow better control when using the drill as a

screwdriver as it prevents over-tightening of the screws.

For drilling, always use the use the Drill position by aligning the Drill symbol with the triangular indicator on the front face of the drill near the torque collar.

For setting the torque position, select a low setting on the torque collar and align the selected symbol with the triangular indicator on the top of the drill. Increase gradually to set the correct torque. It is better to use a scrap piece of material if possible to set the torque.

Inserting and removing bits

This drill has a keyless chuck, which means that a chuck key is not needed to secure a bit in the drill.

1.Open the chuck by holding the rear section of the chuck firm and rotating the front section in a anti-clockwise direction, sufficiently enough to allow the drill bit required to fully enter the jaws of the chuck.

2.Ensure the drill bit is fully inserted, so that the chuck

jaws grip the straight section of the bit.

3.Holding the rear section of the chuck firmly, rotate the front section of the chuck clock-wise until the jaws tighten on the drill bit. The front section of the chuck needs to be tightened firmly to ensure the drill bit is held securely.