Global Machinery Company LDP13B12 instruction manual Unpacking, Required tools, Assembly time

Page 7

Caution! Do not expose to rain or use in damp locations.

Warning! For your own safety read instruction manual before operating drill press. Wear eye protection, do not wear gloves, necktie or loose clothing, clamp workpiece or brace against column to prevent rotation, use recommended speed for drill accessory and workpiece material.

Unpacking

Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.

Required tools

The following tools are required to assemble the drill press

3mm, 4mm, 6mm Hex Keys (Supplied)

Wrench (Not Supplied)

Phillips Head Screwdriver (Not Supplied)

Assembly time

The LDP13B drill press will take approximately 20 minutes to assemble.

7

Image 7
Contents HP 12 Speed Drill Press Contents Introduction SymbolsSpecifications Dear CustomerGeneral safety instructions Safety rules for laser lightsPage Additional safety rules for drill presses Unpacking Assembly timeRequired tools Accessories Know your product Place base on floor AssemblyAdjusting the table height AdjustmentsSetting the drilling depth Installing and removing drill bitsChanging the speed Turning on and off Adjusting the laserOperation General inspection Maintenance CleaningWood drilling Metal drillingTroubleshooting TroubleshootingSave this Manual for future reference