MODEL G5783 |
3⁄8" REVERSIBLE |
ANGLE AIR DRILL |
INSTRUCTION SHEET |
EYE/EAR INJURY HAZARD! Wear safety glasses and hearing protection during use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected 
operation during service!
DO NOT EXCEED 120 PSI! Personal injury could occur.
Introduction
Drill in tight places with this 3⁄8" reversible angle drill. Producing up to 1300 RPM, this angle drill includes a 3⁄8" Jacobs® chuck and chuck key. The large paddle switch also makes this drill easy to use in any position. Requires 90 PSI of air pres- sure with 7 CFM of compressor capacity.
Inventory |
| |
A. | Angle Air Drill | 1 |
B. | Chuck Key | 1 |
C. | Hex Wrench 3mm | 1 |
Operation
Insert your drill bit up to 3⁄8" into the chuck and tighten with the chuck key. Change the drill direc- tion by pushing the reverse valve into the body then rotate to lock into position. Connect the drill to your regulated air source. The hex wrench is included for removing the screw (Ref #55) that holds the chuck to the spindle.
Figure 1. Model G5783.
Air drill MUST have 3-4 drops of air tool oil directly dropped into the air fitting before each use as shown in Figure 2. Keep the head gear lubricated by pumping a small amount light grease into the ball cap on the head.
Figure 2. Lubricating directly into air fitting.
If you need help with your new pneumatic tool, call our Tech Support at: (570)
COPYRIGHT © JUNE, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8322 PRINTED IN TAIWAN