5.From the underside of the workbench, put the appropriate size washers, lock washers and nuts on the bolts (not provided). Tighten all the nuts, securing the Vise Plate (1) to the workbench. Be sure the Vise is securely attached to the workbench before working with the Vise.
Mounting
Holes
Vise Plate (1)
Figure 1
OPERATING INSTRUCTIONS
Thumb on Quick Release Lever (4)
Note: By pushing down on the Quick Release Lever (4), you can release the Jaws so the Jaws can be easily and quickly slid open or closed.
1.Slide the Jaws (2) open by either turning the Handle (3) or using the Quck Release Lever. Place the workpiece you are working on inside the Jaws. Tighten the Jaws (2) against the workpiece by turning the Handle (3) clockwise until your workpiece is held securely.
Caution: Damage could occur if you
2.To remove the object you are working on, turn the Handle (3) counterclockwise two to three times, opening the Jaws (2). Remove your workpiece.
Vise Plate (1)
Jaw Face
Jaw Face
Note: Jaws have threaded holes and countersunk screw holes for attaching wood faces
(not included).
Quick Release
Lever (4)
Handle (3)
Figure 2
SKU 94386 | For technical questions please call | Page 4 |