SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1.USE CLEAN, DRY, REGULATED COMPRESSED AIR AT 90 PSI. Do not exceed the recommended 90 PSI. Never use oxygen, carbon dioxide, combustible gases or any other bottled gas as a power source for this tool.
2.WHEN CONNECTING TO THE AIR SUPPLY:
A.Wrap approximately 4” of Teflon tape around the male threads of a 1/4” NPT Quick Connector (not provided). Then, wrench tighten the Quick Connector into the Air Inlet.
B.If an automatic oiler is not used, add two drops of oil into the Quick Connector.
C.Turn on the compressor and set the regulator to the pressure recommended for this tool (90 PSI).
Air
Drill
Airline Oiler Assembly
3.ALWAYS DISCONNECT TOOL FROM ITS COMPRESSED AIR SUPPLY SOURCE BEFORE PERFORMING ANY SERVICES OR MAINTENANCE such as cleaning the tool, changing chisels or punches, moving to a different work location, handing the tool to another person, etcetera. Caution: After disconnecting the TOOL from the air compressor, the TOOL will still be pressurized. Point the TOOL onto an extra piece of work surface and depress the trigger until all pressure is released.
4.MAINTAIN A SAFE WORK ENVIRONMENT. Keep work area well lit. Make sure there is adequate surrounding work space. Use this product in a well ventilated area. Do not operate this product in the presence of flammable liquids, gasses, or dust.
5.DO NOT FORCE THE EQUIPMENT. This product will do the work better and safer at the speed and capacity for which it was designed.
6.AVOID UNINTENTIONAL STARTING. Make sure you are prepared to begin work before depressing the Trigger.
7.NEVER POINT TOOL AT PEOPLE OR ANIMALS.
8.WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals
SKU 94585 | For technical questions please call | Page 4 |