SpecificationsFunctions
Electrical Input | 120 V~ / 60 Hz / 3.1 A |
|
|
Motor Speed | |
|
|
Chuck Capacity | 1/16” to 3/8” |
|
|
Chuck Type | Keyless |
|
|
| E194601 |
Lock Button (29)
Forward/ 
Reverse Switch
(30)
Speed Limiter
Unpacking
Dial (31)
Trigger
(32)
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Figure 1
1.The Trigger can be locked in the ON position for extended operation. See Figure 1.
Instructions for putting
into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
2.The Keyless Chuck allows the operator to install and remove drill bits without using a key or tools.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation: Release the Trigger
(32)and disconnect from power source before adjusting tool or installing a drill bit.
1.To insert a drill bit, hold the rear ring of the Chuck (5) with one hand while turning the front end clockwise with the other hand to open the jaws.
Rev 10g
SKU 3670 | For technical questions, please call | Page 8 |