3.Set the (1.5 HP minimum) air compressor pressure regulator to 90 PSI. If any air leaking, disconnect the air hose and repair the leak.
4.Grip the Air Drill firmly with both hands and press down on the Trigger (8).
Caution: If the Air Drill will not turn, or if it stalls while drilling, do not raise the outlet pressure of the air compressor. Do not continue with attempts to drill until the problem is resolved.
5.When you are finished drilling, turn the compressor off, then remove the hose connection to the Air Drill.
Maintenance
1.After each use, wipe the Air Drill with a clean cloth to remove any dirt and grease buildup.
2.To maintain tool life, always lubricate the air line by adding a few drops of pneumatic tool oil to the air line before each use. Or, install the automatic
3.Before each use, drain water out of the air compressor tank and condensation from the air lines. Refer to the Air Compressor Operator’s Manual.
Manual Tool Lubrication
1.Disconnect the Air Drill from the air supply and turn it so the Air Inlet fitting is facing upward.
2.Hold the Trigger (8) in and place a few drops of pneumatic tool oil into the air inlet (use SAE #10 weight oil if air tool oil is not available). Holding the Trigger lever in helps circulate the oil in the air motor.
3.Connect the Air Drill to the air supply and cover the Muffler Cover (11) with a towel. Run for a few seconds. Excess oil with be blown out the Muffler Cover.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THat ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 07528 | Page 6 |