Harbor Freight Tools 03670 operating instructions INSPECTION, MAINTENANCE, and Cleaning

INSPECTION, MAINTENANCE, AND CLEANING

Refer to the Assembly Drawing on page 14.

1.WARNING! Make sure the Power Switch of the Drill is in its “OFF” position and that the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

2.BEFORE EACH USE, inspect the general condition of the Drill. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, dam- aged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

3.Periodically check the mounting screws and tighten if necessary.

4.Clean the unit with a damp cloth. Never use solvents to clean the unit.

5.Inspect the chuck and remove any dirt or debris.

6.Inspect the Carbon Brushes (#14) periodically. See the Assembly Drawing on page 9. Remove the Carbon Brush Holder (#15) on the side of the drill. Take the Carbon Brush (#14) out of the Carbon Brush Holder (#15). If it is dirty, use a pencil eraser to clean it. If it is worn, replace it and replace the Carbon Brush (#14). If you replace one Carbon Brush, you must replace them both. Repeat the process with the Carbon Brush Holder (#15) on the other side of the drill.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTUER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 03670 PAGE 12