Buffalo Tools DP5UL operating instructions Important Safety Rules

Page 4

IMPORTANT SAFETY RULES

COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO ANY PRODUCT. THESE FACTORS MUST BE SUPPLIED BY THE OPERATOR.

Keep your work area clean and well lit. Cluttered work benches and dark work areas may cause accidents or injury.

Do not operate drill in explosive areas, such as in the presence of flammable liquids, gases or dust.

The drill may create sparks which may ignite the dust or fumes.

KEEP BYSTANDERS, CHILDREN & VISITORS AWAY WHILE OPERATING THE DRILL.

DISTRACTIONS CAN CAUSE YOU TO LOSE CONTROL.

Double insulated tools are equipped with a polarized plug (one blade is wider than the other.) This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. Do not change the plug in any way. Double insulation eliminates the need for the three wire

grounded power cord and grounded power supply system.

Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is

an increased risk of electric shock if your body is grounded.

Do not abuse the cord. Never use the cord to carry the tool or pull the plug from an outlet. Keep the cord away from heat, oil, sharp edges, or moving parts. Replace damaged cords immediately. Damaged

cords increase the risk of electric shock.

When operating the tool outside, use an outdoor extension cord marked “WA” or “W.” These cords are rated for outdoor use and reduce the risk of electric shock. Make sure the extension cord being used is in good condition. If there are any cuts or nicks (no matter how deep) in the insulation, DO NOT use that cord. Also, make sure the extension cord is heavy enough to carry the current needed. DO NOT use small "around-the- house” lamp extension cords. These cords can easily overheat and/or catch fire when used with power tools.

Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it is designed.

Do not use the tool if the power switch does not turn it “ON” or “OFF”. Any tool that cannot be controlled with the switch is dangerous and must be repaired.

Disconnect the power cord plug from the power source before making any adjustments, changing accessories or storing the tool. These safety measures reduce the risk of starting the tool accidentally.

STORE IDLE TOOLS OUT OF REACH OF CHILDREN AND OTHER UNTRAINED PERSONS. TOOLS

ARE DANGEROUS IN THE HANDS OF UNTRAINED USERS.

PEOPLE WITH PACEMAKERS OR OTHER ELECTRONIC DEVICES SHOULD CONSULT WITH A PHYSICIAN BEFORE OPERATING THIS PRODUCT. INTERRUPTION OR FAILURE OF THE PACEMAKER COULD OCCUR WHEN ELECTRICAL EQUIPMENT IS OPERATED WITHIN CLOSE PROXIMITY OF ELECTRICAL DEVICES.

DP5UL 5 Speed Drill Press Assembly & Operating Instructions

4

 

Image 4
Contents Read ALL Instructions and Warnings Before Using this Product Without prior noticeTable of Contents Specifications FeaturesGeneral Product Specifications Important Safety Rules DP5UL 5 Speed Drill Press Assembly & Operating Instructions Service Save These Instructions for Future ReferenceImportant Safety Instructions Specific Safety Rules AND/OR SymbolsComponents Package ContentsAssorted Loose Parts Resetting the Laser Beam Using the LaserChanging the Batteries Column Assembly to Base Installing the ChuckHead to Column Pulley Cover Knob Fitting the Drive BeltsOperation Settings and AdjustmentsSpindle Depth Changing Drill Speed Removing the Chuck LubricationAccessories TroubleshootingHead Assembly Diagram Quill / Base & Table Assembly Diagram Pulley Assembly