6.Assemble the column (A) Fig. 6, to the base (B) using the four M10x40mm hex head screws (C), three of which are shown.
7.Assemble table raising and lowering handle (D) Fig. 7, to worm gear shaft (E) and tighten screw (F) against flat on shaft with 3mm wrench supplied.
8.Thread table clamp handle (G) Fig. 8, into hole in rear of table bracket, as shown.
A
C
C
B
Fig. 6
F
E
D
Fig. 7
G
Fig. 8
9