Craftsman 137.2191 Assembly tNSTRUCTMONS, Fig B, Tools Needed, Nstalling the Head FIG. G

ASSEMBLY tNSTRUCTMONS

For your own safety, never connect plug to power source outlet until af! assembly and adjustment steps are completed, and you have read and understood the safety and operating instructions.

TOOLS NEEDED

c_ot[edscrewdriver

8" & 10" Adjustabfe wrenches

Combination wrench

Combination square.

Socket wrench-

with 23 ram. socket

The Drill Press is very heavy and MUST be lifted with the help of 2 PEOPLE OR MORE, to safely assemble it.

COLUMN SUPPORT TO BASE (FIG. A)

TABLE TO COLUMN ASSEMBLY (FIG. B THROUGH F)

1.Locate the worm gear, table crank, and table support lock handle from the loose parts bag.

2.Insert the worm gear (1)into the table crank handle hole (2) from inside the table support (3). Make sure the worm gear (!) meshes with the inside ge&r.

3.Insert the table support Jock handle (4) into the hole at the _ear of the table support. Tighten.

NOTE: Table removed from support in illustration for clarity.

Fig_ B

4_ Place the rack (5) in position inside the table support (3), making sure the worm gear (1) on the inside of the table support is engaged with the teeth of the rack.

Fig. C

5' 1

,Slide the table support assembly with the rack (1,3,5)

together onto the column.

6_ Engage the bottom of the rack (5) with the tip of the column support (6). Tighten the support lock handle (4) to lock the table support assembly to the column.

Fig. D

4

3

i

[

J

/i _

:1

,Install the collar (7)to the top end of the rack (5) on the column.

IMPORTANT: The bottom of the collar MUST NOT

be pushed all the way down onto the top of the rack. MAKE SURE the top of the rack is under the bottom of the collar and that there is enough clearance to allow the rack to freely rotate around the column. Tighten the set screw (8).

CAUTION: To avoid column or collar damage, DO NOT OVERTIGHTENthe set screw.

8.Install the table crank handle (9) to the worm gear shaft (1) on the side of the table support (6).

9.Line up the flat side of the shaft with the set screw (!0) in the crank handle and tighten the screw with a hex wrench.

Fig. F

•IO

_NSTALLING THE HEAD (FIG. G)

The Drill Press is very heavy and MUST be lifted with the help of 2 PEOPLE OR MORE,. to safely assemble it.

1Carefully lift head,(1) above the column (2) and slide it onto the column. Make sure the head slides down

over the column as far as possible. Align the head with the base.

2.Using the hex wrench, tighten the two head

lock set screws (3) on the right side of the he,_d.

!.Position base (1)on floor.

2.Place column (2) on 10ase,aligning holes in column support with holes in base,

3., Locate four Ionghex bolts (3) from loose parts bag.

4.Place a bolt in each hole through the column

support and the. base. Tighten with an adjustable' wrench.

Fig. A

2

3

Fig. E	Fig. G
	/-
..........._...-	8

"--""-_"'-_"J-7"--

5

r,:_;, _ : i::':;:k ; :: :-;J i::: : d : q : o:::: i://: {:v _i>::'ij:i, I! :: :::::: :::: :] :::'::