Ryobi 1400677 specifications Operation, Charging Battery Pack, Battery Charger, To Charge

USE1400677 BATTERY CHARGER ONLY WITH BATTERY PACK NOS. 1400651, 1400652, 1400655, 1400671 AND 1400672

CHARGING BATTERY PACK

See Figures 1 & 2.

Battery pack's are shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use.

NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (operating tool followed by recharging batteries) for them to fully charge.

TO CHARGE

■Use 1400677 battery charger only with recommended battery packs. See list above.

■Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.

■Connect charger to power supply.

■Place battery pack in charger aligning raised rib in charger with groove in battery pack.

■Press down on battery pack to be sure contacts on battery pack engage properly with charger contacts.

■Red light should turn on. Red light indicates fast charging mode.

If red light is flashing, this indicates battery pack is deeply discharged or hot.

If battery pack is hot, red light should become steady after battery pack has cooled down.

If battery pack is deeply discharged, red light should become steady after voltage has increased, normally within 30 minutes.

If after one hour red light is still flashing, this indicates a defective battery pack and should be replaced.

Green light on indicates battery pack is fully charged or in slow charging mode to maintain battery pack charge. Yellow light on and red light flashing indicates defective battery pack. Return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.

■When your battery pack becomes fully charged, the red light will turn OFF and the green light will turn ON.

■After normal usage, 1 hour of charging time is required to be fully charged. A minimum charge time of 1-1/2 hours is required to recharge a completely discharged tool.

■The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.

■DO NOT place charger in an area of extreme heat or cold. It will work best at normal room temperature.

■When the batteries become fully charged, unplug your charger from power supply and remove the battery pack.

1400677 BATTERY CHARGER

Fig. 2