Ryobi AG700 Variable Speed Dial, Application Speed Setting, To lock-on, To adjust the handle

OPERATION

lock-off/LOCK-ON BUTTON

See Figure 3.

The lock-off/lock-on button prevents accidental starting of the grinder, and also allows the grinder to be locked-on, which is convenient for continuous grinding/sanding/polishing for extended periods of time.

To lock-on:

Push in and hold the lock-off/lock-on button, located on the side of the handle.

Depress the switch trigger.

Push in further on the lock-off/lock-on button.

Release the switch trigger.

Release the lock-on button and the tool will continue running.

To release the lock, depress and release the switch trigger.

If the lock-on feature is engaged during use and the tool becomes disconnected from the power supply, disengage the lock-on feature immediately.

CAUTION:

Never cover air vents. They must always be open for proper motor cooling.

90˚ ROTATING HANDLE

See Figure 4.

The handle on the tool can rotate 90˚ to the left or right for ease of operation.

To adjust the handle:

Unplug the tool.

Press and hold handle lock button.

Rotate the handle to the desired position and release the handle lock button.

WARNING:

Make sure the handle lock button on the handle clicks and locks into place when changing handle positions. Failure to heed this warning could result in serious per- sonal injury.

VARIABLE SPEED DIAL

See Figure 5.

The variable speed dial allows you to optimize the speed of the tool based on the desired application. Refer to the chart at right for proper speed selection.

lock-off/

LOCK-ON SWITCH

BUTTON TRIGGER

Fig. 3

PUSH
HANDLE LOCK BUTTON
to rotate handle	Fig. 4
variable
speed dial	3

	Fig. 5
Application	Speed Setting
Polishing	1-2
Sanding	3-5
Grinding	6

13