Product Specifications DRILL-DRIVER, Switch, Level

FEATURES

	PRODUCT SPECIFICATIONS:
DRILL-DRIVER	HP62	HP722
Chuck	3/8 in. Keyless	3/8 in. Keyless
Motor	DC Motor 6.0 Volt	DC Motor 7.2 Volt
Switch	Two Speed	Two Speed
No Load Speed	300 - 500 RPM	330 - 500 RPM
Clutch	24 Positions	24 Positions
Charger Input	120 V, 60 Hz, AC only	120 V, 60 Hz, AC only
Charge Rate	3-6 Hours	3-6 Hours

KNOW YOUR DRILL-DRIVER

See Figure 1.

Before attempting to use your drill-driver, familiarize yourself with all operating features and safety requirements.

WARNING:

Carefully read through this entire operator's manual before using your new drill-driver. Pay close attention to the Rules For Safe Operation, Warnings and Cautions. If you use your drill-driver properly and only for what it is intended, you will enjoy years of safe, reliable service.

SWITCH

To turn your drill-driver ON, depress the switch trigger. Release switch trigger to turn your drill-driver OFF.

SWITCH LOCK

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use.

TWO SPEED SWITCH

Your drill has a two speed feature in the switch. Depress the switch trigger halfway for driving screws at a low speed. Depress the switch trigger all the way for normal drilling.

WARNING:

Do not allow familiarity with your drill-driver to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.

KEYLESS CHUCK

Your drill-driver has a keyless chuck that allows you to hand tighten or release drill bit in the chuck jaws.

FORWARD/REVERSE SELECTOR

(DIRECTION OF ROTATION SELECTOR)

Your drill-driver has a forward/reverse selector located above the switch trigger.

BIT STORAGE

When not in use, bits provided with your drill-driver can be placed in the storage area located on the top of the motor housing.

LEVEL

To keep drill bit level during drilling operations, a level is located on the top end of the motor housing.

Page 6

FEATURES