OPERATION
nIf both yellow and green LEDs come on, this indi- cates a deeply discharged or defective battery pack. Allow the battery pack to remain in the charger for 15 to 30 minutes. When the battery pack reaches normal voltage range, the red LED should come on. If the red LED does not come on after 30 minutes, this may indicate a defective battery pack and should be replaced.
nAfter normal usage, a minimum of 1 hour of charging time is required to fully recharge battery pack.
nThe battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
nDo not place the charger and battery pack in an area of extreme heat or cold. They will work best at normal room temperature.
NOTE: The charger and battery pack should be placed in a location where the temperature is more than 50°F but less than 100°F.
nWhen batteries become fully charged, unplug the charger from power supply and remove the battery pack.
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.
NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARGING A COOL BATTERY PACK” for normal recharging of batter- ies. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorized Service Center for electrical check.
TO INSTALL BATTERY PACK
See Figure 4.
n Place the direction of rotation selector in center position.
�n Place the battery pack in your drill. Align raised rib on battery pack with groove in drill’s battery port.
�n Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in drill before beginning operation.
TO REMOVE BATTERY PACK
n Place the direction of rotation selector in center position.
�n Locate latches on side of battery pack and depress both sides to release battery pack from the drill.
�n Remove battery pack from the drill.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.
CHARGER | BATTERY PACK |
|
LATCHES
BATTERY
PACK
| DEPRESS LATCHES TO |
|
Fig. 3 | RELEASE BATTERY PACK | Fig. 4 |
12