Ryobi DP101 warranty Table Adjustments, Mounting Bolts, Table Lock Handle

ASSEMBLY

8.Attach the three feed handles by screwing them into the threaded holes in the hub.

9.Using the pre-drilled holes in the base, mount your drill press securely on a sturdy surface such as a work stand, workbench or counter top. See Figure 9. If your drill press is to be used in a portable application, it is recommended that you fasten it permanently to a mounting board that can be easily clamped to a workbench.

WARNING:

Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury.

Once securely mounted on a sturdy surface, check the following:

■Check for vibration when the motor is switched ON. Adjust and retighten the mounting hardware as necessary.

■Check the table assembly to assure smooth movement up and down the column.

■Check to assure that the spindle shaft moves smoothly.

MOUNTING

BOLTS

Fig. 9

ADJUSTMENTS

WARNING: TABLE CRANK HANDLE

Before adjustment, disconnect the drill press from the power source.

TABLE ADJUSTMENTS

Adjusting the Table Height

See Figure 10.

To adjust table, hold the table with one hand and loosen the table lock handle. Rotate the table crank handle to lower or raise the table. Clockwise raises the table; counterclockwise lowers it. Position the table in the desired position and retighten the lock handle.

TABLE LOCK

HANDLE

Fig. 10

11