Ryobi Comprehensive Guide for Drill Press Users: Battery Installation, Mounting, and Maintenance

 Page 16

assembly

Installing/changing laser batteries

See Figure 13.

Lift head assembly cover from front to open.

Remove cover from battery compartment and install two AA batteries according to the polarity indicated in the compartment.

Reinstall the battery compartment cover.

Close head assembly cover.

WARNING: 

Use of controls or adjustments or performance of pro- cedures other than those specified herein could result in hazardous radiation exposure.

Mounting the Drill press

See Figure 14.

If the drill press is to be used in a permanent location, secure it to a workbench or other stable surface.

If the drill press is to be used as a portable tool, fasten it permanently to a mounting board that can easily be clamped to a workbench or other stable surface. The mounting board should be of sufficient size to avoid tipping while drill press is in use. Any good grade plywood or chipboard with a 3/4 in. thickness is recommended.

■Mark holes on surface where drill press is to be mounted using holes in drill press base as a template for hole pat- tern.

■Drill holes through mounting surface.

■Place drill press on mounting surface, aligning holes in the base with holes drilled in the mounting surface.

■Insert bolts (not included) and tighten securely with lock washers and hex nuts (not included).

If lag bolts are used, make sure they are long enough to go through holes in drill press base and material the drill press is being mounted to. If machine bolts are used, make sure bolts are long enough to go through holes in drill press, the material being mounted to, and the lock washers and hex nuts.

Note: All bolts should be inserted from the top. Install the lock washers and hex nuts from the underside of the workbench.

Once the drill press is securely mounted on a sturdy sur- face:

Check for vibration when the motor is switched ON.

Adjust and retighten the mounting hardware as

necessary­ .

Check the table assembly to assure smooth movement up and down the column.

Check to assure that the spindle shaft moves smoothly.

battery compartment

cover

AA Batteries

head assembly

DANGER / DANGER / PELIGRO

DANGER / DANGER / PELIGRO

Fig. 13

mounting bolts

base

Fig. 14

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents
OPERATOR’S Manual Save this Manual for Future ReferenceWarranty IntroductionGeneral Safety Rules Read ALL InstructionsGeneral Safety Rules Specific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Speed and Wiring ElectricalExtension Cords Electrical ConnectionGlossary of Terms Product specifications FeaturesLaser on/off Depth Switch Tools Needed Aa batteries Head assembly Chuck Table lock Loose Parts Worm Hex bolts BaseAssembly Attaching column assembly to baseColumn ­assembly Hex bolt UnpackingAssembly Installing table assemblyInstalling chuck, head assembly, and feed handles Installing/changing worklight bulbChuck Scrap wood Spindle Head Assembly Feed Handle Set Screws BulbInstalling/changing laser batteries Battery compartment Cover AA Batteries Head assemblyMounting the Drill press Mounting bolts BaseLaser housing Set screw CHECKING/adjusting Laser AlignmentKnob Power Switch Power OffOperation ApplicationsInstalling and removing bits Chuck key Key hole Assembly Table Lock Handle WrongSELF-EJECTING Chuck KEY Table rotationClamp To Adjusting Depth Gauge in the Adjustments section OperationDrilling Drilling TipsAdjustments Adjusting table heightAdjusting Table bevel Adjusting depth GaugeTo change the pulley configuration Changing SpeedsDrive Belt BoltMaintenance General MaintenanceLubrication MOTOR/ELECTRICALTroubleshooting Problem Possible Cause SolutionPage Service Model NO. and Serial no
Related manuals
Manual 26 pages 3.32 Kb
Top Page Image Contents