Switch, LOCK-ON Button, Reversible, Chuck KEY

OPERATION

SWITCH

See Figure 2.

To turn your drill ON, depress the switch trigger. Release switch trigger to turn your drill OFF.

LOCK-ON BUTTON

See Figure 2.

Your drill is equipped with a "lock-on" feature, which is convenient when continuous drilling for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your drill will continue running.

To release the lock, depress the switch trigger and release.

If you have the "lock-on" feature engaged during use and your drill becomes disconnected from power supply, disen- gage the "lock-on" feature immediately.

WARNING:

Before connecting your drill to power supply source, always check to be sure it is not in “lock-on” position (depress and release switch trigger). Failure to do so could result in accidental starting of your drill resulting in possible serious injury. Also, do not lock the trigger on jobs where your drill may need to be stopped suddenly.

REVERSIBLE

See Figure 3.

Your drill has the feature of being reversible. The direction of chuck rotation is controlled by a lever located above the switch trigger. With your drill held in normal operating position, the direction of rotation lever should be positioned to the left of the switch for drilling operation. The direction of rotation is reversed when the lever is to the right of the switch.

The design of the switch will not permit changing the direction of rotation while the drill is running. Release the switch trigger and allow the drill to stop before changing its direction.

NOTE: Your drill will not run unless switch lever is pushed fully to the left or right.

CHUCK KEY

See Figure 4.

A chuck key has been provided for use when installing or removing bits. It is also used when removing the chuck. (See chuck removal section).

CHUCK KEY STORAGE

See Figure 4.

For storage when not in use, the chuck key has been attached to the power cord. A key strap has been used. One end of the key strap is attached to the chuck key, while the other end is attached to the power cord.

LOCK-ON

BUTTON

SWITCH TRIGGER	Fig. 2
FORWARD/REVERSE LEVER	FORWARD

REVERSE

Fig. 3

POWER

CORD

KEY

STRAP

CHUCK KEY

Fig. 4

Page 6