Removing Bits

OPERATION

See Figure 3.

Unplug the drill.

Rotate the chuck sleeve clockwise to open the chuck jaws.

Note: Rotate the chuck body in the direction of the ar- row marked UNLOCK to loosen the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.

Remove the drill bit.

lock-on button

See Figure 5.

This drill is equipped with a lock-on feature, which is con- venient for continuous drilling for extended periods of time. To lock-on:

Depress the switch trigger.

Push in and hold the lock-on button, located on the side of the handle.

Release the switch trigger.

Release the lock-on button and the drill will continue running.

To release the lock, depress and release the switch trig- ger.

If the lock-on feature is engaged during use and the drill becomes disconnected from the power supply, disengage the lock-on feature immediately.

WARNING:

Before connecting the drill to a power supply source, always check to be sure it is not in lock-on position (de- press and release the switch trigger). Failure to ensure that it is not locked-on could result in accidental starting of the drill resulting in possible serious injury. Do not lock the switch trigger in applications where the drill may need to be suddenly stopped.

CHUCK BODY

UNLOCK

(RELEASE)

DRILL BIT

CHUCK	LOCK
CHUCK	(TIGHTEN)
JAWS	(TIGHTEN)	CHUCK
JAWS		CHUCK
	RIGHT	COLLAR
	RIGHT	Fig. 3
		Fig. 3

WRONG

Fig. 4

LOCK-ON BUTTON

11 − English

Fig. 5