Ryobi CFS1503K manual Attaching Hook-and-loop Sanding Sheets, Attaching the Dust Bag

OPERATION

Sheet/Pad	Recommended Use
Heavy scrubbing pad	Paint and rust removal
(Part no. CFS1501-36)
Light scrubbing pad	Light scrubbing and cleaning
(Part no. CFS1501-37)
Polishing pad	Polishing
(Part no. CFS1501-38)
60-grit sanding sheet	Coarse sanding
(Part no. CFS1501-33)
120-grit sanding sheet	Light sanding
(Part no. CFS1501-34)
240-grit sanding sheet	Finish sanding
(Part no. CFS1501-35)

Attaching Hook-and-loop Sanding Sheets

See Figure 2.

Unplug the sander.

Align holes in hook-and-loop type sanding sheet with holes in pad, then carefully press fuzzy side of the sand- ing sheet against pad as tightly as possible.

NOTE: Hook-and-loop type sanding sheets can be reused for the life of the sanding abrasive. It is rec- ommended that you keep the sanding sheet back- ing clean to provide for best adhesion. Clean the sheet and hook-and-loop pad by brushing lightly with a light brush.

Attaching the Dust Bag

See Figure 3.

The dust bag provides a dust collection system for the sand- er. Sanding dust is drawn up through the holes of the sanding sheet and collected in the dust bag during sanding.

Unplug the sander.

Using a slight twisting motion, firmly slide dust bag as- sembly over blower exhaust on sander.

Turning THE SANDER On/Off

See Figure 4.

While holding the tool in normal operating position:

Push the ON/OFF switch to the left to turn sander on.

Push the ON/OFF switch to the right to turn sander off.

hook-and-loop pad

sanding sheet

Fig. 2

dust bag

blower exhaust

Fig. 3

on off

Fig. 4

10