OPERATION
nAfter normal usage, a minimum of 1 hour of charging time is required to fully recharge battery pack.
nThe battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
nDo not place the charger and battery pack in an area of extreme heat or cold. They will work best at normal room temperature.
NOTE: The charger and battery pack should be placed in a location where the temperature is more than 50°F but less than 100°F.
nWhen batteries become fully charged, unplug the charger from power supply and remove the battery pack.
CHARGING A HOT BATTERY PACK
When using the worklight continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before at- tempting to recharge. When the battery pack becomes dis- charged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.
NOTE: This situation only occurs when continuous use of the worklight causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARG- ING A COOL BATTERY PACK” for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check.
CHARGER
BATTERY
PACK
Fig. 3
TO INSTALL BATTERY PACK
See Figure 4.
�n Begin with a fully charged battery pack.
nOrient battery pack so that raised rib on battery pack aligns with groove inside worklight. Battery pack is de- signed to fit only one way in worklight handle.
�n Insert battery pack, making sure latches on each side of battery pack snap in place and battery pack is secure in worklight before use.
CAUTION:
When placing battery pack in the worklight, be sure raised rib on battery pack aligns with groove inside worklight and latches snap into place properly. Improper installa- tion of the battery pack can cause damage to internal components.
LATCH
BATTERY
PACK
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 4
10