Ryobi FL1800 manual Operation, Charging Flashlight, To INSTALL/REMOVE Battery Pack

Page 6

OPERATION

CHARGING FLASHLIGHT

If your flashlight did not come in a cordless kit with other cordless products, a battery pack and charger were not included. If you need to purchase a battery pack, request recommended battery pack part number 1322401, 1323303,130256001, 130224007 or 130255004. If you need to purchase a charger, request recommended charging as- sembly part number 1423701. If your flashlight came with a kit, use the battery pack and charger included with the kit.

TO CHARGE BATTERY PACK:

Charge battery pack only with the charger recom- mended.

Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.

Connect charger to power supply.

TO INSTALL/REMOVE BATTERY PACK

See Figure 1.

Begin with a fully charged battery pack.

Orient battery pack so that raised rib on battery pack aligns with groove inside flashlight. Battery pack is designed to fit only one way in flashlight handle.

Insert battery pack, making sure latches on each side of battery pack snap in place and battery pack is se- cure in flashlight before use. NOTE: When placing bat- tery pack in your flashlight, be sure raised ribs on battery pack aligns with groove inside flashlight handle and latches snap into place properly. Improper insertion of battery pack can cause damage to internal components.

To remove battery pack, locate latches on end of bat- tery pack and depress to release battery pack from your flashlight.

DANGER:

RISK OF ELECTRIC SHOCK. DO NOT TOUCH UNINSULATED PORTION OF OUTPUT CONNECTOR OR UNINSULATED BATTERY TERMINAL.

Place battery pack in charger then press down on battery pack to be sure contacts on battery pack en- gage properly with charger contacts.

Red light should turn on.

When battery pack is fully charged, the red light will turn off and the green light will turn on.

After normal usage, 1 hour of charging time is required to be fully charged. A minimum charge time of 1-1/2 hours is required to recharge a completely discharged battery pack.

LED FUNCTION OF CHARGER

LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK:

Red LED lighted = Fast Charging Mode

Green LED lighted = Fully Charged Battery Pack

Yellow and Green LED Lighted = Control Charge or Defective Battery Pack.

WARNING:

Do not operate flashlight or charger near flammable liquids or in gaseous or explosive atmospheres. Internal sparks can ignite fumes.

LATCH

BATTERY

PACK

DEPRESS LATCHES TO

Fig. 1

RELEASE BATTERY PACK

WARNING:

If wrapped or in contact with fabric, the flashlight lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the flashlight lens to come in contact with anything.

Page 6

Image 6
Contents OPERATOR’S Manual Volt Cordless Flashlight Model NO. FL1800 Save this Manual for Future ReferenceTable of Contents General Safety RulesImportant Rules for Battery Tools Specific Safety Rules AND/OR SymbolsService Tool Use and CareImportant Safety Instructions For Charger Symbols Symbol MeaningSymbol Name DESIGNATION/EXPLANATION Charging Flashlight To INSTALL/REMOVE Battery PackOperation LED Function of ChargerSwitch Trigger Rotating Head Bulb Storage Area Lens Cover SwitchBulb Replacement Rotating HeadMaintenance BatteriesPage Operators Manual Volt Cordless Flashlight Model NO. FL1800