UNPACKING
Your Compound Miter Saw has been shipped completely assembled except for the battery pack, dust bag or dust guide.
WARNING:
If any parts are missing, do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
■Remove all loose parts from the carton. Separate and check with the list of loose parts. See Figure 1.
■Remove the packing materials from around your saw.
■Carefully lift saw from the carton and place it on a level work surface. Although small, this saw is heavy. To avoid back injury, get help when needed.
■Do not discard the packing materials until you have carefully inspected the saw, identified all loose parts, and satisfactorily operated your new saw.
■Your saw has been shipped with the saw arm locked in the down position. To release saw arm, push down on top of saw arm and pull out the lock pin. See Figure 7.
■Lift the saw arm by the handle. Hand pressure should remain on the saw arm to prevent sudden rise upon release of the lock pin.
■Examine all parts to make sure no breakage or damage has occurred during shipping.
If any parts are damaged or missing, do not attempt to turn the switch on until the damaged or missing parts are obtained and are installed correctly.
■If any parts are damaged or missing, please call
TOOLS NEEDED
The following tools (not included) are needed for checking adjustments of your saw or for installing the blade:
17 mm COMBINATION WRENCH
10 mm COMBINATION WRENCH
PHILLIPS SCREWDRIVER
| COMBINATION |
FRAMING SQUARE | SQUARE |
|
Fig. 1
Page 9