ADJUSTMENTS
WARNING:
Before performing any adjustment, make sure the bat- tery pack is removed from tool and the switch is in the OFF position. Failure to heed this warning could result in serious personal injury.
POSITIVE 0° BEVEL STOP
See Figure 24.
The saw has a positive 0° bevel stop that has been factory adjusted to assure 0° angle of the saw blade when making 90° cuts.
CHECKING POSITIVE 0° BEVEL STOP
nPlace the saw in an upside down position on a work- bench.
nCheck the squareness of the saw blade to the base of the saw using a carpenter’s square.
ADJUSTING POSITIVE 0° BEVEL STOP
nLoosen bevel adjustment knob.
nTurn setscrew with hex key and adjust base until it is square with the saw blade.
nTighten bevel adjustment knob securely.
WARNING:
Attempting a bevel cut without having the bevel ad- justment knob securely tightened can result in serious injury.
ADJUSTMENT
SCREW
| 5 |
| 0 |
| 45 |
30 |
|
22 |
|
15 |
|
| 0 |
0 | 4 |
5 | |
| 1 |
| 2 |
HEX NUT
POSITIVE 0°
BEVEL STOP
CARPENTER'S
SQUARE
BEVEL
ADJUSTMENT
KNOB
BLADE
Fig. 23
21