Installing the workshelf, 2 x 9, 4 in. Wood

OPERATION

nInsert the 3/4 x 7-1/2 in. plywood strip horizontally be- tween the 6 in. strips, making sure the long edge is flush with the base.

nPre-drill and countersink two holes; install screws.

NOTE: The corners of the shelf can now be mitered, if desired, to remove sharp edges.

nPlace the 3-1/2 x 9 in. piece of plywood horizontally 1-3/4 in. above the vertical plywood strips. Make sure the left and right edges of the wood are flush with the sides of the base.

nPre-drill and countersink two holes in the center of wood as shown.

Installing the workshelf:

nRemove the 3-1/2 x 9 in. plywood and insert shelf between top and bottom rails of miter stand until edge of vertical strips touch miter stand front rail.

nPlace the 3-1/2 x 9 in. plywood between the front and back rails of the miter stand. Re-align the pre-drilled holes in the top piece with the pre-drilled holes in the base of the shelf.

nInstall screws in pre-drilled holes to secure shelf.