Powermatic PF3-JR operating instructions Grounding Instructions, Volt Operation

Page 11

Grounding Instructions

Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be properly grounded to help prevent electrical shock and possible fatal injury.

This Stock Feeder must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment-grounding conductor and a grounding plug similar to the one shown in Figure 6. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified electrician.

Improper connection of the equipment- grounding conductor can result in a risk of electric shock. The conductor, with insulation having an outer surface that is green with or without yellow stripes, is the equipment- grounding conductor. If repair or replacement of the electric cord or plug is necessary, do not connect the equipment-grounding conductor to a live terminal.

Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded. Use only three wire extension cords that have three-prong grounding plugs and three-pole receptacles that accept the tool’s plug.

Repair or replace a damaged or worn cord immediately.

115 Volt Operation

As received from the factory, your Stock Feeder is ready to run at 115 volt operation. It is intended for use on a circuit that has an outlet and a plug that looks similar to the one illustrated in Figure 6.

A temporary adapter, which looks like the adapter as illustrated in Figure 7, may be used to connect this plug to a two-pole receptacle, as shown in Figure 7, if a properly grounded outlet is not available. The temporary adapter should only be used until a properly grounded outlet can be installed by a qualified electrician. This adapter is not applicable in Canada.

11

Figure 6

Figure 7

Image 11
Contents Roll Powered Stock Feeder More Information Warranty and ServiceTable of Contents Page Page Introduction Description SpecificationsFeatures Unpacking Contents of the Shipping ContainerTools needed for assembly Assembly and InstallationPage Volt Operation Grounding InstructionsEdgewise Stock Feeder Position AdjustmentsExtension Cords Basic Feeder/Stand MovementsSpeed Selection General Operating Instructions Operating ControlsOperation When Used with a Shaper Roller Removal/Replacement MaintenanceWhen Used with a Table Saw When Used with a JointerGearbox LubricationChains Replacement Parts TroubleshootingIndex No. Part No Description Size Qty Parts List PF3-JR Stand AssemblyPF3-JR Stand Assembly Parts List PF3-JR Stock Feeder PF3-JR Stock Feeder PF3-JR Electrical Connections Scale Boring TemplatePage Page Vantage Drive Elgin, Illinois Phone