Husqvarna manual Starting and Stopping, Starting and stopping, Before starting K3000 Wet

Page 15

STARTING AND STOPPING

Starting and stopping

WARNING! Note the following before

!starting:

The machine should be connected to an earthed outlet socket.

Check that the mains voltage corresponds with that stated on the rating plate on the machine.

Make sure you have a secure footing and that the cutting blade cannot touch anything.

Keep people and animals well away from the working area.

Before starting (K3000 Wet)

Water connector

Connect the water hose to the water supply (A). The water flow is regulated using the water tap (B).

Ground fault circuit interrupter

Make sure the ground fault circuit interrupter is switched on. The LED indicates that the ground fault circuit interrupter is on and that the machine can be switched on. If the LED is not on, push the RESET button (green).

Check the ground fault circuit interrupter. See instructions under the heading Checking, maintaining and servicing the machine’s safety equipment.

Starting

•Grip the front handle with the left hand.

•Grip the rear handle with your right hand.

•Press in the power switch lock with your right-hand thumb and press in the power switch.

•Run the machine unloaded and in a safe manner for at least 30 seconds.

Stopping

WARNING! The cutting blade continues to

!rotate for some time after the motor has stopped.

Stop the motor by releasing the power switch.

English – 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents English K3000, K3000 WetKEY to Symbols Symbols on the machineSymbols in the operator’s manual Contents What is what on the power cutter K3000? What is WHAT?What is what on the power cutter K3000 Wet? Safety Instructions Steps before using a new power cutterPersonal protective equipment General safety warnings Work area safetyElectrical safety Cutting blades Personal safetyPower tool use and care ServiceGradual start and overload protection Machine′s safety equipmentSwitch Power switch lockGround fault circuit interrupter K3000 Wet Cutting bladesGeneral Diamond blades Abrasive discsWet cutting with diamond blade K3000 Wet General working instructionsCutting technique Dry cutting with diamond bladeHow to avoid kickback Guard for the blade AssemblyAssembly Fitting the cutting bladeStarting Starting and StoppingStarting and stopping Before starting K3000 WetMaintenance MaintenanceDaily maintenance Checking water connection with flow limiterChanging the grease Cutting equipment Technical DataPage 1151199-95 ´z+S3¶52¨ ´z+S3¶52¨
Top Page Image Contents