Operating Instructions & Parts Manual | Model WG3013 |
|
|
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
|
| Wire Feed |
| TM | Arc Welder |
BUILT TO LAST |
|
|
|
|
|
|
| URAN | CE |
|
|
|
|
|
| SS | P |
| ||
|
|
| A |
|
|
| ||
|
| Y |
|
|
| R |
| |
|
|
|
|
| O | |||
| T |
|
|
|
| G | ||
AL | I |
|
|
| Need | R | ||
|
|
|
|
| A | |||
U |
| Assistance? | M | |||||
Q |
|
| ||||||
Call Us First!
Description
This line of Campbell Hausfeld wire feed welders is designed to be used on standard 115V household current. The welders are equipped with infinite wire speed control to accurately select the proper wire feed rate needed for various welding conditions. Internal components are thermostatically protected.
These welders are designed for use with Flux Core Arc Welding (Gasless) or Gas Metal Arc Welding (Mig) process. As delivered from the factory, this welder can weld with .024” (.6 mm) to .035”
(.9 mm) diameter wire. A starter spool of .035” (.9 mm)
.040 tip are included.
Unpacking
Some welder components may be found in the wire feed compartment.
When unpacking, inspect carefully for any damage that may have occurred during transit. Report any damaged or
7
2
Figure 1
4
1
6 
5 
3
FARMHAND 125
missing items by calling (800)
Circuit Requirements
This equipment ! CAUTION requires a dedi-
cated 115 volt circuit. Refer to the following chart for the correct circuit breaker or fuse rating. Do not run other appliances, lights, or tools on this circuit while operating this equipment. Extension cords are not recommended. Blown fuses and tripped circuit breakers can result from failure to comply with this recommendation.
| Heat | Circuit Breaker or | ||||
| Selector | Slow Blow Fuse | ||||
|
|
|
|
|
|
|
| Low | 15 amp | ||||
|
|
|
|
|
|
|
| High | 20 amp |
|
|
| |
|
|
|
| |||
|
|
|
| |||
|
|
|
|
|
|
|
Components and Controls
1.Ground Clamp - connect to work piece.
2.Wire Feed Gun with .040 tip
3.Power Cord - plug into 115 volt outlet.
4.On/Off Switch
5.Infinite Wire Speed Control - turn clockwise to increase wire speed and counterclockwise to decrease wire speed.
6.Heat Selector - Selects welding power. Four selections are possible
7.Polarity
General Safety
Danger means a hazard that will
cause death or serious injury if the warning is ignored.
Warning means a hazard that could
cause death or serious injury if the warning is ignored.
Caution means a ! CAUTION hazard that may
cause minor or moderate injury if the warning is ignored. It also may mean a hazard that will only cause damage to property.
NOTE: Note means any additional information pertaining to the product or its proper usage.
© 2000 Campbell Hausfeld / Scott Fetzer | For parts, product & service information | IN970400AV 11/00 |
visit www.chpower.com