Python 232-835 owner manual Section C, Accessories/Options

Section C

table top, with the other hand give the Removal Tool a quick snap-turn in the CLOCKWISE DIRECTION.

3.Once the drive roll is loose, continue to spin drive roll in the clockwise direction to remove the drive roll from the gun.

Figure 2

4.Install a new drive roll on the left-hand threaded shaft. The drive roll will self-tighten when it is feeding wire.

Idler Roll Installation and Removal

(Reference Figure 3)

1.Using a slot type screwdriver, loosen idler screw, taking care not to lose lock washer under idler roll.

2.Insert new idler roll and lock washer onto screw, insuring that idler groove is toward top and lock washer is beneath.

3.Tighten.

Figure 3

NOTE: Lock washer must be under idler roll or it will not turn freely.

Accessories/Options

Insulated Drive Roll Kits are used to prevent preheating of the wire which may soften it and clog the liner. This picking up of current at the drive rolls rather than at the contact tip is usually not a problem unless using too large of a contact tip or excessively oxidized aluminum wire.

Insulated Groove Drive Roll Kit 005-0640

For .030" (0.8mm) dia. aluminum wire. Includes insulated groove drive roll and insulated idler roll assy.

Insulated Groove Drive Roll Kit 005-0716

For .035" (0.9mm) dia. aluminum wire. Includes insulated groove drive roll and insulated idler roll assy.

Insulated Groove Drive Roll Kit 005-0642

For .040" (1.0mm) dia. aluminum wire. Includes insulated groove drive roll and insulated idler roll assy.

Insulated Groove Drive Roll Kit 005-0718

For 3/64" (1.2mm) dia. aluminum wire. Includes insulated groove drive roll and insulated idler roll assy.

Insulated Groove Drive Roll Kit 005-0644

For .062" (1.6mm) dia. aluminum wire. Includes insulated groove drive roll and insulated idler roll assy.

Handle Kit 005-0699

Includes left and right handles, screws and drive roll door.

Python® Lincoln Compatible™ Owner's Manual - Page 3